![]() ![]() The Problem: When you install the Visual Micro plug-in for Studio 6.x, you are most likely to be using the Arduino serial bootloader, since Visual Micro's programming and debugging capability is based upon the USB-serial link between the PC and the Arduino board. This is the Jungo driver, and while you have the option of not installing the Jungo driver during the Studio install process, you can't use the Atmel AVRISP mk II nor the Atmel JTAGICE3 without this driver. When you install Studio 6.1/ 6.2 however, the Atmel installation will install it's own USB driver, which work with the Studio6.x IDE. If you have a blank Mega328 that has not had the boot-loader firmware pre-installed), you can do so from the Arduino IDE using the Tools/Burn Bootloader function- after having specified the AVRISP mk II as the programmer using Tools/Programmer function. ![]() Also, if you need to actually program an AVR MCU with the bootloader code itself (i.e. Using Atmel's AVRISP mk II Programmer with the Visual Micro plug-in for Atmel Studio IDE Overview: When you install the Arduino IDE, a USB driver is installed so that you can use the Atmel AVRISP mk II programmer as an alternative to using the Arduino serial Boot-loader.
0 Comments
Leave a Reply. |